Applied in tubes, ducts, trays, blocks, tunnels, collecting channels, with no risk of rodent attacks. Also applied for aerial installation between supports and buildings on external strength members or using the winding method.
Applied in ducts, trays, blocks, tunnels, collecting channels, with a risk of rodent attacks.
Applied in harsh environments with potential mechanical impact: in all ground types, swamps and harsh rivers.
Applied in sea areas (coastal shelf and deep-sea), on navigable rivers, in lakes and water storage basins, in harsh environments, in bogs and unnavigable rivers.
Applied for aerial installations: on power lines, lamp posts, between buildings and constructions. Suitable for aerial installation on transmission equipment and power facilities in dielectric package.
Applied for aerial installation on distribution and high voltage power lines, as well as railway catenary.
Applied inside buildings (including vertical runs), in trays, channels, on outer sides of buildings, as well as in duct, in tubes and blocks. Suitable for blowing-in into protecting polyethylene tubes.
Applied for aerial installation on transmission towers, lamp posts, between buildings and constructions.
Applied in the construction of fiber-optic link on overhead transmission lines of 35 kV and more.
Used for stationary installation when the optical fiber needs extra protection from mechanical damages.
For fiber optic monitoring systems.
Steel optical module, clad wire and temporary optical cable.
Overhead cable with an external strength member is used for building communication systems in cities, where towers are located close to each other. The cross-section of this cable type is 8-shaped.
Cables with an external strength member are easier to install, however they have certain limitations related to the maximum permissible tensile load.
Have a question?
Send a request